HAIRCUT PROFESSIONAL TH36 Manuel D'utilisation page 21

USE
C
HARGING THE BATTERY
It is essential to charge the battery for about 2 hours before using the
equipment for the first time. Charge the equipment at least once during the
year following the date of delivery. The battery reaches its full capacity after
3 or 4 charging cycles.
 The equipment must only be used with the
power pack it was supplied with.
 WARNING: To recharge the battery, use
only the removable power pack supplied
with the equipment.
When charging, it is advisable to switch the equipment off (On/Off switch set
to 0, Fig. 1-B).
▪ Insert the electrical lead into the socket of the equipment (Fig. 2).
▪ Connect the power pack (Fig. 1-K) to a mains power socket.
▪ When completely charged, the equipment can be used without the electrical lead.
O
PERATION
When first used, lubricate the blades by applying a drop of oil to the points
shown (Fig. 4).
S /
WITCHING ON OFF
▪ Switch the equipment on by pressing the On/Off switch (Fig. 1-B).
▪ To stop the equipment , press the On/Off switch again (Fig. 1-B).
▪ When the equipment is not in use, it is advisable to clip the cutter cover (Fig. 1-N)
onto the blades.
U
SE WITH OR WITHOUT ELECTRICAL LEAD
▪ With a new, fully charged battery, the equipment can be used without the power
lead for about 150 minutes.
▪ Charge the battery of the equipment before the end of the autonomy period, refer
to § 3.1.
Use only with the
HP06A-051000-AVE-S
power pack
21