Pulsar PWP10 Guide D'utilisation page 9

Operating Instructions & Parts Manual
1 Inch Water Pump
Discharge Hose Installation
Use a commercially available hose and hose connector, and
clamp provided with the pump.
It is best to use a short, large-diameter hose, because that
will reduce fluid friction and improve pump output. A long
or small-diameter hose will increase fluid friction and reduce
pump output.
Tighten the hose clamp securely to prevent the discharge
hose from disconnecting under high pressure.
Priming The Pump
Before starting the engine, remove the filler cap from the pump chamber, and completely fill the pump chamber
with water. Reinstall the filler cap, and tighten it securely.
Note:
Operating the pump dry will destroy the pump seal. If the pump has been operated
dry, stop the engine immediately, and allow the pump to cool before priming.
Priming Water
Filler Cap
Hose Clamp
9
Hose Clamp