Braun 5793 Mode D'emploi page 12

• For first-time charge, charge continuously for at
least 1 hour.
• The actual charge status is shown on the display.
Display
• The display information is dependent on the
model.
• Some models only show icons during charging or
operation. On other models a series of icons is
also shown after the shaver has been turned off.
• The table below shows the icons that can appear
on the shaver display.
Battery status
The battery status is shown
with segments and additionally
in digits (for some models also
with a battery icon).
• The status segments appear /
• The digital number shows the
Plug reminder
(low charge / cordless operation only)
1. Flashing: Battery is in low
2. Fast flashing: This appliance
Travel lock
When the travel lock icon
appears on the display, the
shaver is locked.
Replacement indicator
for Foil & Cutter cassette
The replacement indicator
shows the usage of the
Foil & Cutter cassette. The
status segments disappear
gradually with the numbers of
shaves*.
Cleaning indicator
(with Clean & Charge station usage only)
The cleaning indicator lights
up after each shave as
a reminder that the shaver
should be cleaned in the
Clean & Charge Station.
*not with all models
12
disappear gradually with the
status of the battery power.
remaining shaving time in
minutes.
charge, i.e. 5 minutes
shaving time are left.
can only be operated
cordless. Disconnect the
shaver from the power supply
before turning it on.
Usage
Make sure that the shaver is disconnected from the
power supply. Press the on / off button (4) to
operate the shaver.
Tips for a perfect shave
1. Position the shaver at the right angle (90°)
to your skin.
2. Stretch your skin slightly with your hand.
3. Shave against the direction of your beard growth.
Multi Head Lock switch (head lock)
The shaver head can be locked in five positions to
shave hard-to-reach areas (e.g. under the nose).
• Slide the Multi Head Lock switch (3) down to lock
the shaver head.
• Move the shaver head manually to your desired
position.
• For automatic cleaning in the Clean & Charge
Station the head lock needs to be released.
Precision trimmer
The trimmer can be used to trim sideburns,
moustache or beard.
• Press the release button (8) and slide the trimmer
(6) upwards.
Travel lock
The shaver can be locked to avoid unintended
starting of the motor (e.g. for storing in a suitcase).
• Press the on / off button (4) for 5 seconds to lock /
unlock the shaver. This is confirmed by a beep
sound and the lock icon appearing / disappearing
on the display.
Foil replacement
To maintain 100% shaving performance, replace the
Foil & Cutter cassette (1), when the foil replacement
indicator lights up (and no status segments are
visible).
• To remove the Foil & Cutter cassette press the
release buttons (2).
• Press the on / off button for 10 seconds to reset
the counter.
• Afterwards you need to unlock the shaver
(see chapter «Travel lock»).
• On some shaver models the replacement indicator
will reset automatically after 7 shaves.
Cleaning
Cleaning under running water
Especially important after foam or gel usage
• Switch on the shaver cordless and rinse the
shaver head under hot running water until all
residues have been removed. You may use liquid
soap without abrasive substances. Rinse off all
foam and let the shaver run for a few more seconds.
• Next, switch off the shaver, press the release
buttons (2) to remove the Foil & Cutter cassette (1)
and let it dry.