Philips HP8540/01 Mode D'emploi page 10

EnglisH
10
- The measuring tape automatically rewinds when you move the red tab sideways.
The appliance is now ready for use.
using the appliance
1 Fully unwind the mains cord.
 Put the plug in the wall socket.
 Consult chapter 'Tanning and your health' and your own notes for the correct tanning time.
 Put on the protective goggles.
- Only use these protective goggles when you tan with a Philips tanning appliance. Do not use
them for other purposes.
- The protective goggles comply with protection class II according to directive 89/686/EEC.
5 Set the timer to the appropriate time for the tanning session (Fig. 12).
The maximum tanning time that can be set is 45 minutes.
6 Lie down under the lamp unit.
The appliance beeps during the last minute of the session.
,
During this minute, you can reset the timer to tan the other side of your body. If you reset
,
the timer during this minute, you avoid the 3-minute waiting time which is necessary to let
the tanning lamps cool down after they have switched off.
The timer automatically switches off the tanning appliance when the set tanning time has
,
elapsed.
after the tanning session
1 Use the memory knobs to keep track of the number of tanning sessions you have had. The
appliance has two memory knobs: one for each person (Fig. 13).
cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
Do not let any water run into the appliance.
1 Unplug the appliance and let it cool down before you clean it.
 Clean the outside of the appliance with a damp cloth.
 Clean the outside of the UV filter with a soft cloth sprinkled with some methylated spirits.
 Clean the protective goggles with a moist cloth.
storage
1 Let the appliance cool down for 15 minutes before you put it in transport position and store
it.
 In the meantime, you can wind up the cord and put it in the base of the appliance.
Note: Make sure the cord is stored properly and does not get stuck between the hinging parts of the
appliance when you put the appliance in transport position.
 Slide the collar down the stand (1) to unlock the height adjustment lock. Push the stand
down at the same time (2). Then let go of the collar (Fig. 14).
 Turn the lamp unit a quarter turn (Fig. 15).
All manuals and user guides at all-guides.com