Publicité
Les langues disponibles
Les langues disponibles
Assembling the Door
(A3)
(A1) (A2)
(A3)
Parts
A1
A2
A3
A4
A5
A6
G
K
1. Identify and lay out the parts (A1-A6) as shown.
2. Insert parts (A3) into the receiving tube pieces on part (A2). Make sure door frame is fully inserted,
then tighten the two set screws.
NOTE: Part (A2) has a 1" extended leg; make sure you position this at the bottom.
3. Attach part (A1) to the upper and lower frame (A3) bars. Make sure it is fully inserted, then tighten
the two set screws.
4. Run tension rods (A5) through the sides of the mesh (A4).
5. Hook a gate clip (G) to the center of the door frame and snap into place on the tension rod.
Secure four more clips evenly spaced, top-to-bottom. (FIG. 2).
6. Repeat on opposite side of the door.
7. Once door is fully assembled, slide onto the outer door frame (A6). Slide top of (A2) over the
downward pointing tube at the top of (A6). Press as high up as you can. Line up with the upward
pointing tube at the bottom of (A6), and let it fall gently into place.
8. Lay assembled door (A) mesh-side down. Loosen set screw on bottom (FIG. 3).
9. Attach chain link fabric to door frame using two metal tie wires (K) on both the top and bottom.
For best results, attach to the middle knuckle of the chain link fabric (FIG. 1).
03/30/22
NOTE: Assemble the door with the parts laying flat on the ground.
(A5)
(A6)
(G)
Image
(A4)
Description
Door Frame - Latch Side (65")
Door Frame - Fixed Side (66.75")
Upper & Lower Door Frame Bars
Chain Link Mesh - Small
Tension Rods - Short Round (62")
Outer Door Frame - Fixed Side (72")
Gate Clips
Metal Tie Wires
(K)
(K)
FIG. 1
(G)
FIG. 2
FIG. 3
(K)
Page 2 of 10
Quantity
1
1
2
1
2
1
10
4
Publicité
