Blyss KPT-2000B 5203L Mode D'emploi page 8

FAN and HEATING (ONLY by remote control)
- Press to switch on the appliance.
≡
- Press to select one of the following modes :
Fan without heating
- Press again to switch off the appliance.
Stops by going into standby (the fan stops
30 seconds after the stand-by).
TEMPERATURE CONTROL (ONLY by remote control)
- Press to switch on the appliance.
- Press + or - to set the setting temperature
from 15°C to 35°C (the light °C is on).
≡
- Press to cancel the temperature setting
(the light °C is off) and to choose the heating
on half power ( I ) or full power ( II ).
.The heater working on full power when the room temperature is 4°C lower
than the setting temperature.
.The heater working on half power when the room temperature is between
0° and 2°C lower than the setting temperature.
.The heater switches off when the room temperature is 2°C higher than the
setting temperature.
.The heater switches on again when the room temperature falls 2°C below
the setting temperature.
≡
≡
Heating on full power
8
Heating on half power
Quick start
≡