BGS technic 1705 Mode D'emploi page 4

This tensioning Gauge can be used to adjust the tension on the cam belts where the movement of the
timing belt is measured by load (Nm). Suitable for use on cam belts with various belt thickness (For
belts other than 5mm thickness see Cam Belt Size below)
• Easy to use
• Clear incremental marking with knurled knob for precise measurement
• Dual scale allows reading from top or bottom of tool (Large and small numbers for compatibility)
ALWAYS USE MANUFACTURERS' RECOMMENDATIONS FOR CAM BELT TENSION AND
POSITION OF MEASUREMENT. (e.g. between the timing gear and the water pump pulley).
SW-Stahl und Werkzeugvertriebs GmbH
L e v e k r u s r e t S a r s s e 6 5
D 4 - 2 8 9 7 R e m s c h e d i
Belt Gauge
Tel. +49 (0) 2191 / 46438-0
F ax +49 (0) 2191 / 46438-40
- E M a : l i n i o f @ s w s a t
Art. 1705
l h d . e