Publicité
Les langues disponibles
Les langues disponibles
10.8 night light replacement
Your appliance comes equipped with our Night Light ™. The light has
been pre-wired and can be controlled from the remote control.
It is recommended that the Night Light ™ be in the "OFF" position when
the appliance is on.
In the event the lamp or lens needs to be replaced:
•
Unplug the appliance from power.
•
Remove the 4 screws that secure the lens frame. This frame retains
the glass lens.
•
The lamp can now be accessed. It will pull straight out of the socket.
note:
Do not handle the lamp (bulb) with bare fingers as it may be
hot. Use a clean, dry cloth for protection.
•
Replace the lamp with Wolf Steel parts only, as lamp and lens are
special "high temperature" products.
•
When re-installing, ensure integrity of gasket seal.
note:
Do not over-tighten the screws, as this could break the lens.
THE FIREBOX MUST BE SEALED.
"Light leakage" from the upper area may be noticed. The holes in the lamp housing are necessary for ventilation
and must not be covered.
10.9 blower replacement
WARNING
!
•
Ensure the appliance is completely cool before starting installation.
•
To avoid danger of suffocation, keep the packaging bag away from babies and children. Do not use in cribs,
beds, carriages or play pens. This bag is not a toy. Knot before throwing away.
Remove the safety barrier by lifting it up and off of the appliance.
A.
Remove the door from the appliance by releasing the door latches.
B.
Remove cover plates (Fig. 1).
C.
(Fig. 1)
finishing
LENS ASSEMBLY
SCREWS
FIREBOX TOP
W415-4065 / B / 01.30.23
EN
FRAME
LENS
GASKET
(Fig. 2)
53
Publicité
