Publicité
Les langues disponibles
Les langues disponibles
Cookware for induction cooking zones
The Induction element can only be turned on when cookware with a magnetic
base is placed on one of the cooking zones. You can use the cookware identified as
suitable below.
Cookware material
Cookware material
Steel, Enamelled steel
Cast iron
Stainless steel
Aluminium, Copper, Brass
Glass, Ceramic, Porcelain
NOTE
•
Cookware appropriate for induction cooking is labelled as suitable by the
manufacturer.
•
Certain cookware can make noise when being used on induction cooking
zones. These noises are not a fault in the appliance and do not affect operation
in any way.
Using the correct size cookware
•
The Induction Cooking Zones require that you use pots and pans of a
minimum size or larger at each location. The inner ring of each Cooking Zone
is your guide to the correct minimum pan size. The pan bottom must fully
cover the inner ring for proper cooking to occur.
•
The thicker outer ring at each Cooking Zone is helpful to determine the
maximum pan size. After centering the cookware on the cooktop, make sure
the cookware does not extend more than 1/2" beyond the thicker line on the
Cooking Zone. The pan must fully contact the glass surface without the bottom
of the pan touching the metal cooktop trim.
NE63B8611-03_IB(FULL)_EN+MES+CFR.indb 27
NE63B8611-03_IB(FULL)_EN+MES+CFR.indb 27
Suitable
Yes
Yes
If appropriately labelled by the manufacturer
No
No
NOTE
•
If a pan made of the correct material is centered properly on any of the active
Cooking Zones but is too small, the affected Cooking Zone display will flash
and the pan will not heat.
•
If cookware is unsuitable, too small, or no cookware has been placed on the
cooking zone,
will be displayed. After 30 seconds, the corresponding cooking
zone will turn off.
Pot and pan sizes
Induction cooking zones adapt automatically to the size of the bottom of the
cookware up to a certain limit. However the magnetic part of the bottom of the
cookware must have a minimum diameter depending upon the size of the cooking
zone.
Cooking
Minimum diameter of the
zones
bottom of the cookware
1
5.2 inches (130 mm)
2
4.5 inches (110 mm)
3
7.25 inches (180 mm)
English 27
2023-10-13 오후 2:14:14
2023-10-13 오후 2:14:14
Publicité
