Arp Section; Effect Section - Access Virus TI Série Guide De Démarrage Rapide

32 QUICKSTART MANUAL

Arp Section

The Arpeggiator is used to create automatic arpeggios (broken chords) out of any notes you hold together.
You can select from any one of 64 pre-defined rhythmic patterns, or even make one of your own (User) us-
ing the pattern editor in Virus Control.
• Arp On
Switches the Arpeggiator on/off.
• (Arp) Edit
Press this to gain access to all parameters relevant to the Arpeggiator. Please note that most are unavailable
when the Arpeggiator is switched off.

Effect Section

Effects are like the final icing on your cake of sound. The entire output of the sound-engine passes through
the Effects section, where you can use several different FX types to take a basic sound and turn it into a
production-ready epic.
• Select
Each row of effects has its own SELECT button. Press it repeatedly to move the focus of the adjacent knobs
through the selection of effects in that same row.
Effects In Upper Row
Effect
Delay
Reverb
Low EQ
Meaning
An echo effect, in which you can control the amount of echo (SEND), the time
between echoes (TIME) and how long the echoes take to fade out (FEEDBACK/
DAMPING). A Tape Delay mode is also available - for details, please refer to the
user manual.
Simulates the reverberation of an acoustic space. You can set the amount of
reverberation (SEND), the length (TIME) and the decay rate of high frequencies
(FEEDBACK/DAMPING).
Attenuates (reduce) or boosts the amount of low frequency (bass) content in the
sound by up to +/-16dB. Use EQ GAIN to set the desired level, and EQ FREQ to
set the frequency below which the Gain is applied.