Accessories; Crevice Tool - HAEGER WET & DRY Série Mode D'emploi

Accessories

Picking up liquid matter
Before picking up liquid matter, ensure that the rubber nozzle is fully inserted in
the suction aperture.

Crevice tool

The crevice tool can be inserted into the suction aperture to clean crevices,
corners and other areas difficult to reach.
Crevice brush
The crevice brush can be fitted to the crevice tool and is suitable for cleaning
uneven surfaces such as computer keyboards etc.
Operation
- Remove the vacuum cleaner from its wall bracket.
- If required, fit any of the nozzle attachments to the suction aperture.
- Switch on the appliance using the On/Off switch.
- Always ensure that the dust container is emptied in good time, before the
dust or liquid matter collected reaches the level of the inner suction tube.
- If the vacuuming power decreases during operation, the appliance will
automatically switch off to prevent the battery from being over-discharged.
Recharge the battery if this occurs.
- The autonomy of the vacuum cleaner is around 18 min. Recharge the
battery if it is discharged.
- For a good vacuum result, always start with a clean filter.
Cleaning
General
- Before cleaning the appliance, remove the vacuum cleaner from the wall
bracket.
- To avoid the risk of electric shock, do not clean the appliance or the
adapter with water and do not immerse them in water.
- If necessary, the housing may be wiped with a damp cloth. Wipe dry
afterwards.
To empty the dust container
- Reduced vacuuming power despite a fully charged battery pack indicates
that the dust container and filter inlay must be emptied.
Instructions for use
English
3