MINN KOTA MKR-30 Mode D'emploi page 5

Connecting the Wire Harness to the Trolling Motor
Once the Wire Harness is connected to the Power Switch, it should be connected to the trolling motor.
1
a. Locate the Foot Pedal Power Cord on the trolling
motor. It will exit the base of the mount on the trolling
motor next to the Power Leads. The Cord will have a
Plug covered by a Cap at the end. Unscrew the Cap
on the Plug by turning it counterclockwise.
b. Locate the 7-pin Plug on the Wire Harness. When
holding the Wire harness at the "Y" with the molded
Minn Kota logo right-reading, the correct Plug is
above the "Y". A Cap will cover the 7-pin Plug at
the end. Unscrew the Cap on the Plug by turning it
counterclockwise.
c. Align the 7-pin Plug from the Wire Harness with the
Plug on the Foot Pedal Power Cord. Firmly push the
Plugs together. Secure the connection by rotating
the collar on the Foot Pedal Power Cord in a
clockwise direction.
The connectors are keyed to prevent
NOTICE:
reversed installation.
Leave caps in place to prevent water
NOTICE:
intrusion when not connected.
Connecting the Wire Harness to the Foot Pedal
If it is desired that the Foot Pedal is connected to the trolling motor, complete the connection of the Foot Pedal to the Wire Harness.
1
a. Locate the 4-pin Plug on the Foot Pedal. A Cap will
cover the 4-pin Plug at the end. Unscrew the Cap on
the Plug by turning it counterclockwise.
b. Locate the Plug for Power Connection on the Wire
Harness. When Holding the Wire Harness at the
"Y" with the molded Minn Kota logo right-reading,
the Power Connection is below the "Y". The Power
Connection will have a Plug covered by a Cap at the
end. Unscrew the Cap on the Plug by turning
it counterclockwise.
5 | minnkota.johnsonoutdoors.com
Foot Pedal Foot Pedal
1a
Power Cord Power Cord
from Trolling from Trolling
Plug Plug
Cap Cap
1b
Plug Plug
7-pin Plug 7-pin Plug
from Wire from Wire
Harness Harness
Cap Cap
Molded Molded
"Y" "Y"
Wire Harness Wire Harness
1c
Foot Pedal Power Cord Foot Pedal Power Cord
from Trolling Motor from Trolling Motor
1a 4-pin Plug from 4-pin Plug from
Plug Plug
Cap Cap
1b
Plug Plug
Cap Cap
Power Power
Connection Connection
Molded Molded
Motor Motor
7-pin Plug 7-pin Plug
from Wire from Wire
Harness Harness
7-pin Plug from 7-pin Plug from
Wire Harness Wire Harness
Foot Pedal Foot Pedal
Power Power
Connection from Connection from
Wire Harness Wire Harness
"Y" "Y"
Wire Harness Wire Harness
©2023 Johnson Outdoors Marine Electronics, Inc.