Publicité
Les langues disponibles
Les langues disponibles
4
g.
Once all four corners inside of the intended mounting
location are drilled, take a Rotary tool, keyhole saw,
or similar cutting tool to connect the corners.
h.
Using the cutting tool, connect the four drilled
holes in the shape of a rectangle. Cut the inside
perimeter lines between the four drilled corners of
the small rectangle.
i.
With the inside perimeter cut to connect the four
drilled corners, the rectangular hole in the mounting
location should fall out or be easily removed. If used,
remove the masking tape covering the mounting
location. Use a file or sandpaper to smooth the edges
of the mounting hole if desired.
5
ITEM(S) NEEDED
j.
Take the Mounting Plate (Item #8) and press the
Remote Power Switch (Item #2) into it. The screw
hole recess for the Mounting Plate should face
forward. Press the pieces together until the Remote
Power Switch is fully inserted.
k.
Take the Mounting Plate with the Remote Power
Switch installed and place it over the mounting hole
cut into the Mounting Location. Make sure the Switch
is right-reading.
l.
Take the four #6 x 1/2 Phillips Head Screws
(Item #10) and place one screw in each hole.
m. Using a #2 screwdriver, install the screws on the four
corners of the Mounting Plate. Hand tighten.
3 | minnkota.johnsonoutdoors.com
4g
#8 x 1
#2 x 1
Drilled
Drilled
Holes
Holes
Drilled
Drilled
Holes
Holes
Drilled
Drilled
Holes
Holes
4i
#10 x 4
5j
Screw Hole
Screw Hole
Recess
Recess
Remote Power
Remote Power
Switch
Switch
Mounting
Mounting
Plate
Plate
5l
Phillips Head
Phillips Head
Screws
Screws
Phillips
Phillips
Head
Head
Screws
Screws
4h
Drilled
Drilled
Holes
Holes
Lines
Lines
Drilled
Drilled
Holes
Holes
Mounting
Mounting
Surface
Surface
Rectangle
Rectangle
removed
removed
5k
Mounting
Mounting
Location
Location
Remote
Remote
Power
Power
Switch
Switch
5m
Complete Typical
Complete Typical
Installation
Installation
©2023 Johnson Outdoors Marine Electronics, Inc.
Cut
Cut
Publicité
