MINN KOTA MKR-30 Mode D'emploi

Compatible with Ulterra QUEST and Riptide Instinct QUEST trolling motors.
Item /
Part # Description
Assembly
2 2374015 SWITCH-REMOTE POWER (BLACK)
2374106 FACEPLATE-RMT PWR SWTCH BLK (BLACK)
4
2374105 FACE PLATE-REMOTE PWR SWTCH (WHITE)
6 2377415 HARNESS 30',RMT PWR SWITCH
2376466 FACEPLATE, RCKER SWITCH BLK (BLACK)
8
2376467 FACEPLATE, RCKER SWITCH WHT (WHITE)
10 2373408 SCRW-#6X½ PH THRED FRMNG SS
s 2377180 INSTR.SHEET,MKR-30 P.SWITCH
✖ This part is included in an assembly and cannot be ordered individually.
s Not shown on Parts Diagram.
TOOLS AND RESOURCES REQUIRED
• Flat Blade Screwdriver
• Awl
• Scissors
MOUNTING CONSIDERATIONS
The Remote Power Switch is a common rocker style switch. When operating the Remote Power Switch, the switch returns to its start
position after being pressed. If installed and connected to a power source, the LED on the Remote Power Switch is illuminated when the
switch is "on". The brightness of the LED on the Remote Power Switch is parallel to the brightness of the LEDs on the trolling motor to which
the switch is connected. Refer to the trolling motor manual to set the LED brightness. The Remote Power Switch is designed to be installed
on a standard marine switch panel.
Before installing the Remote Power Switch, please give
consideration to the following:
1. The panel switch opening should be 0.83 in (53/64") wide
and 1.45 in (1-29/64") high.
2. The panel thickness accepting the Remote Power Switch
should be between 1/32" and 3/16" thick.
3. The Switch Face Plate needs a flat mounting location of no less than 1.97" wide and 2.59" high.
4. Ensure the area under the mounting location is clear, and the Remote Power Switch will not damage or obstruct existing components
or wiring below the mounting surface.
5. Make sure that the trolling motor Power Leads and Wire Harness provided with the Remote Power Switch are not connected to a
power source before installation.
6. Test that the Wire Harness can reach the intended mounting location. The Wire Harness is 30' long and needs to reach from the
Remote Power Switch to the trolling motor. It is recommended that there is enough slack in the Wire Harness to route in a manner that
it is not a tripping hazard for the final installation.
There are three options for installing the Remote Power Switch:
1. Install the Remote Power Switch on a standard marine panel
already present on the boat.
2. Complete the installation of the Remote Power Switch following the directions provided.
3. Have the installation completed by a qualified marine technician.
1 | minnkota.johnsonoutdoors.com
MKR-30 TM REMOTE POWER SWITCH
Qty.
1
1
1
1
1
1
4
1
• #2 Phillips Screwdriver
• Drill
• 7/64" (0.109) Drill Bit
8
10
• Masking Tape
• File or sandpaper
WARNING
Make sure the power source is disconnected or, if controlled by
a switch, turned OFF before beginning installation of the Remote
Power Switch. Failure to remove power from the trolling motor
could cause electric shock.
If uncomfortable making this installation,
NOTICE:
Minn Kota recommends to have the Remote Power Switch
installed by a qualified marine installer.
1865130
4
2
6
• Rotary tool, keyhole saw, or
similar cutting tool
©2023 Johnson Outdoors Marine Electronics, Inc.