Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Installing the Remote Power Switch
Minn Kota recommends installing the Remote Power Switch on a standard switch panel. This may be as simple as inserting the switch into
an existing switch panel. If installing the Remote Power Switch into an existing switch panel is not an option, follow the instructions below to
custom install the Remote Power Switch at the desired location. If custom installing the Remote Power Switch, Minn Kota recommends having
a flat mounting surface that measures no less than 1.97" wide and 2.59" high . The mounting surface should be flat and free to drill holes.
Review the mounting considerations at the beginning of the installation for all mounting recommendations.
1
a.
Review the mounting considerations at the beginning of
the installation and select a mounting location.
b.
Take scissors and cut out the mounting template. It is
located on the back of the clam card included in the
packaging. Cut out the center rectangle of the template
where the Remote Power Switch Body will be installed.
It may be necessary to cover the
NOTICE:
intended location with masking tape to prevent
any unintended scuffs or minor imperfections
that may be caused by slipping or scratches from
installation tools.
2
c.
Place the template over the mounting location.
Make sure the direction of the template matches
the intended direction of the Remote Power Switch.
If necessary, place the Remote Power Switch over
the template to double-check the intended
mounting position.
d.
Use an awl or similar tool to mark all four screw holes
on the corners of the template. Mark the four corners
on the inside of the template where the rectangle
was removed. The inside rectangle will measure
0.83" wide by 1.45" high when complete. Mark
the perimeter of the rectangle on the inside of the
template. Set the template aside.
3
e.
Use a Drill with a 7/64" (0.109) Drill Bit to drill all four
of the screw holes.
f.
Drill all four corners on the marked location on the
inside of the small rectangle. The four drill holes that
make up a small rectangle on the inside of the
template will be connected to make a hole in the
mounting location.
2 | minnkota.johnsonoutdoors.com
1a
Mounting
Mounting
Surface
Surface
2c
Template
Template
Marked
Marked
Locations
Locations
Marked
Marked
Locations
Locations
Mounting
Mounting
Surface
Surface
2d
Marked
Marked
Location
Location
Mounting
Mounting
Surface
Surface
3e
Drill Screw
Drill Screw
Holes on
Holes on
Marked
Marked
Locations
Locations
1b
Template
Template
Marked
Marked
Locations
Locations
3f
Drilled
Drilled
Holes
Holes
Drill Screw
Drill Screw
Holes on
Holes on
Marked
Marked
Locations
Locations
Drilled
Drilled
Holes
Holes
©2023 Johnson Outdoors Marine Electronics, Inc.
Publicité
