Getting Started; Important; Choose A Location - CLEANCUT CC3100 Manuel D'installation

GETTING STARTED

1 . Remove all packing material .
2 . Remove and save literature .
3 . Unpack mounting washers, screws and spacers for mounting and set them aside in a safe
place where they will not roll away or get lost .
IMPORTANT: Do not attempt to operate appliance until it is properly installed. This appli-
ance will be damaged if operated while sitting on a surface or on its side.

CHOOSE A LOCATION

When choosing your location, consider the following:
DO make sure to mount within reach of an electrical outlet .
•
DO consider your normal work patterns in the kitchen when choosing location . As
•
this will become your most used kitchen appliance, it is recommended to mount the
CLEANCut™ close to your sink or food prep area .
DO NOT mount over any heating or cooking appliance such as your range or oven .
•
DO NOT mount under, in front of or behind any under-cabinet light fi xtures .
•
CAUTION: When selecting a location for your CLEANCut™, make sure you have
adequate room to reach the power jack. Be sure to unlatch the main body to ensure that
nothing hits the power jack.
CAUTION: There needs to be a minimum of 13-1/4" of space between the surface that the
CLEANCut™ is mounted to and the counter top.
DETERMINE CABINET TYPE
Prior to taping the mounting template and beginning to drill your holes, determine if your
cabinet has a fl at bottom
INSTALLATION; if the cabinet has a lip, refer to SPACER MOUNTING INSTALLATION.
[B]
6
or an overhanging lip
[ B ]
. If your cabinet is fl at, follow STANDARD
[ C ]
[ C ]