Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
PROBLEM
CLEANCut™ does not
dispense paper
Paper does not load
12
POSSIBLE CAUSE
Power adapter is not
plugged into the wall
Power cord connector is not
plugged into the power jack
Main body is open
Power cord is hitting roll
Paper is jammed
Main body is not fully open
First sheet is either curled
or damaged
Paper path is clogged
Cutter is blocking the path
SOLUTION
Make sure the power adapter
is plugged into a live outlet
Fully press power cord
connector into the power jack
Close the main body and
make sure the opening
latch is fully locked
Use cord management
hooks to keep power cord
from hitting the paper roll
Unplug the power cord
connector then remove
any jammed paper . Replug
power cord connector
Push the main body
completely down to fully open
Tear off the first sheet to
make sure its flat
Make sure the main body
is fully open and clear any
loose paper
Unplug and replug the power
cord connector to reset cutter
Publicité
Table des Matières
