CLEANCUT CC3100 Manuel D'installation page 10

9 . Plug power cord connector into the
power jack in the back of the appliance .
Plug the power adapter into a standard
electrical outlet . Extra cord should be
hung over cord management hooks
behind unit
[ E ]
CAUTION: Make sure power cord does not fall into the roll.
NOTE: If you wish to conceal the power cord, drill a 3/8" hole through the bottom of the
cabinet fl oor at the rear and to the side of the cabinet. Now the power cord connector can
be run down through the 3/8" hole and connected to the power jack. The power adapter can
be plugged into a standard electrical outlet available inside the cabinet. If this outlet is not
available then one can be installed by a qualifi ed electrician.
10 . Your CLEANCut™ appliance is now ready for use! For operating instructions, see the
HOW TO USE section of this manual .
OVERHANG LIP INSTALLATION
IMPORTANT: Always wear protective glasses or goggles to prevent injury when drilling.
1 . Clear counter top under installation
area to avoid getting dust or debris
on other appliances or items . Open
cabinets and remove contents to make
mounting easier .
2 . Fold mounting template along Overhang Lip Fold Line . Place template under cabinet
with fold line fl ush against inside overhang, and tape securely in place
NOTE: Use center line to align unit with center of cabinet if desired.
IMPORTANT: Do not align screw holes on template with the partition between cabinets, as
this will prevent you from installing the appliance properly. Pay close attention to where the
drill holes will be set so as not to damage your cabinets during mounting. Drilling through your
cabinet's partition may cause damage to cabinets and prevent proper installation.
3 . Drill from under the cabinet up . Drill holes through the 4 places marked on the
template using a 1⁄ 4 -inch drill bit .
IMPORTANT: Always ensure you are drilling straight up through the marked mounting
hole on the template. Drilling at an angle may prevent proper installation and may damage
cabinets if the drill bit pierces the partition.
8
.
[ E ]
[ F ]
.
[ F ]