Water/ Temperature - Steinberg SBS-PW-402C Manuel D'utilisation

4. Overload Warning
Please do not add item that is over the maximum capacity. When the scale is
ringing an alarm, remove the item on the platter to avoid damage to the load cell.
5. Unit price setting
To trade with your scale, it is necessary to setting a unit price of the goods, EPS-1
PR then uses this unit price to determine how much value of that goods (placed
on the platter).
When the scale id displaying the weight of the goods placed on the scale, set the unit
price through numeric keys. Set unit price is showed in UNIT PRICE window display,
TOTAL PRICE window display shows the total price of the goods. To cancel the previ-
ous unit price, press C key.
Accumulator Operation
1. Prepare to accumulate
Each time before accumulate, please make sure the platter is empty, the current
EN
accumulator values is reset to zero, and the weight reading is stable.
2. Accumulation operation
Put the weighing item on platter, wait for the weight reading to be stable, press
the Add key, the window will show Add n being the number of times a count
operation had been performed. If you have entered the Unit Price for that item;
the accumulate operation will show the total Price as follows: Place an item on
Platter, allow the scale reading to be stable; enter unit price using numeric keys,
Unit price window will show the Unit price and Total price window will show
total price. Now, press Add key, it will store the value of price. Now, remove the
first item from the platter, place another item on the scale; allow it to be stable,
Enter Unit price using numeric keys, after observing Unit price and Total pri-
ce, press Add key again. The Unit price window will flash Add 2. and Total price
window will show accumulated price. You can carry on this way for 99 times with
your scale.
3. Accumulate Clear
You can clear the accumulated value by pressing C (Clear) key at any time.
12
Unit Price Storage
Steinberg Systems scale can store 7 sets unit price.
1. Store the unit price
Press STORE key; then enter desired unit price using numeric keys. Now press
M* (*=1 to 7) key. The value will be stored into respective M* (* =1 to 7) key. If
you have already entered any value in that key, it will be replaced by new value.
2. Load the unit price
If you want to use the unit price stored in the scale, while weighing; than press
respective M* (*= 1 to 7) key after the weighing display is stable. The Unit price
will be loaded and it will be displayed in Unit Price Window.
Caution
1. Battery
The battery must be recharged properly after use of the scale without Mains
power. Normally; charge for 1.2 hr for each use of 1 hr of scale. If it is not used
for longer time; than charge it continuously at least for 24 hours. Otherwise it
will cause damage to battery. Never connect battery in reverse polarity. Ensure
that the Scale's +ve is connected with Battery +ve and Scale's –ve is connected
with Battery –ve. Remark: Before you begin to charge battery , please turn off the
scale frist.

2. Water/ Temperature

Protect your scale from Heavy Raining, Water flooding and also from Direct
Sunlight and High temperatures (above 50 deg. C). This scale is not a Water proof
scale.
3. Humidity
Protect it from the constant humidity; DO NOT install near humidifier
4. Magnetic Field
Do not install your scale near Strong Magnetic Field. It may damage delicate parts
of your scale.
5. Repair / Maintenance
Do not try to open the scale by your self OR by unauthorized technical person.
This may damage the scale permanently. Always contact your nearest dealer /
service station for emergency repairs.
13
EN