PROLED FLEX STRIP IP20 Mode D'emploi page 42

7. Soldering of cables at IP53 Flex Strips
If you have to solder a connection to a Flex Strip IP53, please work according to following steps.
Cut the Flex Strip on marked cutting line.
Cover the soldering point with acid free silicone
for example PROLED sealing glue L6396.
Cover the soldering point with heat shrink tube
MBN GmbH, Balthasar-Schaller-Str. 3, 86316 Friedberg - Germany
Montageanleitung / Installation manual
. Remove silicone from the soldering pads and
Solder the cable correctly. Please take care about
correct polarity.
Cut a small piece of heat shrink tube.
Take care that the security foil of the adhesive tape
can be removed.
www.proled.com
19