PROLED FLEX STRIP IP20 Mode D'emploi page 39

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation must be made on a heat disposal underground, which is adequate dimensioned, to remove the
heat of the desired Flex Strip. The underground must be free of greas, oil, silicone, dust and dirt. We suggest
Isopropanol for cleaning.
Installation on uneven, low heat-conductive grounding is not suggested as the life time will be shorted and
make fixing difficult. These include wood, plaster board, wallpaper etc.
Avoid fixing over profile splice. Because of thermal expanding or shrinking a damage of Flex Strip can happen.
Divide the Flex Strip in this case and use flexible connections, for example wire strap.
Installation steps:
1. Remove the protection foil of the adhesive tape
2. Place the Flex Strip in the profile and stuck it gently. Do not use any sharp or metallic tools.
MBN GmbH, Balthasar-Schaller-Str. 3, 86316 Friedberg - Germany
Montageanleitung / Installation manual
Lower side with adhesive tape
www.proled.com
16

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Flex strip ip53Flex strip ip67

Table des Matières