Kohler K-6486 Guide D'installation page 4

Cut Line
Rail
Preparation
Remove the false drawer front from your cabinet. Use care not to
damage the cabinet.
TIP: Apply painter's tape to the cabinet to mark cuts and protect
cabinet surfaces when cutting.
Measure in 7/8" (22 mm) from the outside edge of the sink base
cabinet. Mark this distance onto the cabinet. Repeat for the other
side.
Cut along each marked line until the cut extends slightly beyond
the top of the drawer opening/top rail of the cabinet.
Following the bottom edge of the rail, extend your cut until it
intersects with the previous cut. Repeat for the other side.
If your cabinet has a center support, cut along the bottom of the
support even with the drawer opening.
Remove and discard the top rail.
1159655-2-B
7/8" (22 mm)
Inside Wall
Center
Support
Rail
4 Kohler Co.