5.2 Dry mode
1. Press the
button (B3). The
and the display shows the "
2. The appliance automatically operates at the maximum
dehumidifying capacity.
Note:
The Dry mode is recommended for particularly humid
environments or to dry laundry more quickly.
6. TIMER FUNCTION
•
The timer can be used to delay appliance start-up and
shut-down. This will avoid energy wastage, ensuring the
appliance operates only when needed.
•
When programming is enabled, The
How to programme delayed start-up
1. With the appliance in stand-by mode, press the
(B4). The
light (C6) is on and the display shows the
number relative to the selected hours flashing (fig. 9);
2. Set the desired number of hours by repeatedly pressing the
button (B4). 1, 2, 4, 6, 8, 12 hours can be selected.
3. After a few seconds, the appliance will return to stand-by
mode and the
light (C6) will remain lit on the display.
4. After the programmed time, the appliance will turn on in
the previously set operating mode.
How to programme delayed shut-down
1. With the appliance running, press the
light is on and the display shows the number relative
to the selected hours flashing (fig. 9);
2. Set the desired number of hours by repeatedly pressing
button (B4). 1, 2, 4, 6, 8, 12 hours can be selected.
3. After a few seconds, the display returns to the current
operating mode and the
4. After the programmed time, the appliance will
automatically turn off.
Note:
•
Once the timer has been programmed, to see the
remaining time until start-up or shut-down, press the
button once.
•
To disable the timer function, press the
the
light (C6) on the display will turn off.
7. CLEANING AND MAINTENANCE
•
Always disconnect the appliance from the mains before
carrying out cleaning operations.
•
For safety reasons, never wash the dehumidifier using a
water jet.
7.1 Cleaning the cabinet
•
Clean the appliance using a damp cloth then dry with a dry
cloth.
•
Never use petrol, alcohol or solvents to clean the appliance.
light (C2) turns on
" symbol (fig. 8).
light is on.
button
button (B4): The
light (C6) remains lit.
button twice,
•
Never spray the appliance with insecticides or similar.
These could cause the plastic parts to warp.
7.2 Cleaning the dust air filter or silver-ion air
filter (on certain models only)
If the filter is dirty, air circulation is compromised and the ef-
ficiency of dehumidifying is decreased. It is therefore good
practice to clean the filter at regular intervals. The frequency
depends on the environment and the duration of operation.
If the unit is used constantly or systematically, you are recom-
mended to clean the filter once a week.
• To remove the air filter, remove the grill and extract the filter
by pulling it (see Fig. 10).
• Use a vacuum cleaner to remove dust accumulations from
the filter. If the filter is very dirty, rinse well with lukewarm
water. The temperature of the water should not exceed 40˚C.
After washing the filter, allow it to dry completely before
reinserting it. If present, the silver-ion air filter, besides re-
taining powder particles, has also an efficient antibacterial
action. In addition, it greatly reduces irritants such as pollen
and spores.The filter is treated with small particles of silver
(on the scale of millionths of a millimetre) which are able to
block the multiplication of and destroy any bacteria or spores
coming into contact with them.
7.3 Anti-allergen filter (on certain models only)
Some models are equipped with an anti-allergen filter that can
notably reduce the concentration of allergens transported by air
in a quick and efficient way.
To apply the filter, remove it from the packaging and insert it
into its place in the grill at the back of the appliance, as shown
in Figure 11.
It is recommended to replace the filter every 2 years.
7.3.1 Activated carbon filter (only in certain models)
Certain models are equipped with an activated carbon filter that
helps reduce odours.
Note: The activated carbon filters cannot be washed and/or rege-
nerated; therefore, they must be replaced after about 1 year of use.
7.4 For long periods of downtime
• After unplugging the appliance from the power socket,
empty the tank.
• Clean and reposition the filter.
• Cover the appliance with a plastic bag to protect it from dust.
8. TECHNICAL SPECIFICATIONS
Power supply voltage
Rated input power
Maximum input power
Defrost device
Hygrometer
Fan speed
10
See rating plate
"
"
Yes
Yes
2