Télécharger Imprimer la page

Husqvarna LC 221RH Manuel D'utilisation page 12

Masquer les pouces Voir aussi pour LC 221RH:

Publicité

Les langues disponibles

Les langues disponibles

Start the engine and then release the engine brake
handle. If the engine does not stop in 3 seconds, let
an approved Husqvarna service agent adjust the
engine brake.
To do a check of the rear deflector
The rear deflector decreases the risk that objects eject
in the direction of the operator.
Make sure that the rear deflector is not damaged.
Make sure that the springs that close the rear
deflector are not broken.
Replace broken springs and damaged parts.
Make sure that the rear deflector can move smoothly
on the hinges.
To do a check of the side discharge deflector
The side discharge deflector is attached to the side
discharge opening of the product. It decreases the risk
of objects to eject in the direction of the mow position of
the operator.
1. Make sure that the side discharge deflector is not
damaged.
6
2. Examine the side discharge deflector. Make sure
that you do not see defects, such as cracks or
broken springs that push the door to close.
3. Replace the side discharge deflector or the springs if
they are damaged.
Muffler
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Do not use the product if the muffler is missing or
defective. A defective muffler increases the noise level
and the risk of fire.
WARNING: The muffler becomes very hot
during and after use and when the engine
operates at idle speed. Be careful near
flammable materials and/or fumes to prevent
fire.
To do a check of the muffler
Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
To do a check of the oil level
CAUTION: A too low oil level can do
damage to the engine. Do a check of the oil
level before you start the product.
1. Put the product on level ground.
2. Remove the oil tank cap with the attached dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank to give a correct
picture of the oil level.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again.
Fuel safety
WARNING: Read the warning instructions
that follow before you use the product.
Do not start the product if there is fuel or engine oil
on the product. Remove the unwanted fuel/oil and let
the product dry.
If you spill fuel on your clothing, change clothing
immediately.
Do not get fuel on your body, it can cause injury. If
you get fuel on your body, use soap and water to
remove the fuel.
Do not start the product if the engine has a leak.
Examine the engine for leaks regularly.
1205 - 002 - 08.07.2019

Publicité

loading