Installation Instructions; Tools And Parts; Optional Pedestal - Maytag MHP1000SQ0 Guide D'utilisation Et D'entretien

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the
instructions provided with any tools listed here.
Flat-blade screwdriver
#2 Phillips screwdriver
Adjustable wrench that opens to 1"
(2.5 cm) or hex-head socket wrench
(for adjusting dryer feet)
Wire stripper (direct wire installations)
Level
Parts supplied
Remove parts packages from dryer drum. Check that all parts are included.
NOTE: Do not use leveling legs if installing the dryer on a pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting. See "Electrical
Requirements" and "Venting Requirements" before purchasing parts.
For close-clearance installations between 31.5" (80.01 cm) and 37" (93.98 cm), see "Plan
Vent System" section for venting requirements.
Mobile home installations require metal exhaust system hardware available for purchase from
the dealer from whom you purchased your dryer. For further information, please refer to the
"Assistance or Service" section.
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with clothes dryers. The kit should
contain:
A UL listed 30-amp power supply cord, rated 120/240 volt minimum. The cord should be
type SRD or SRDT and be at least 4 ft (1.22 m) long. The wires that connect to the dryer
must end in ring terminals or spade terminals with upturned ends.
A UL listed strain relief.
4

INSTALLATION INSTRUCTIONS

Vent clamps
Caulking gun and compound (for
installing new exhaust vent)
Tin snips (new vent installations)
¼" nut driver (recommended)
Tape measure
4 Leveling legs
37"
(93.98 cm)

Optional Pedestal

Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of
different heights separately for this dryer. You may select a 10" (25.4 cm) pedestal or a
15.5" (39.4 cm) pedestal with a storage drawer. The pedestal will add to the total height of the
dryer for a total height of approximately 46" (116.8 cm) or 51.5" (130.8 cm), respectively.
For a garage installation, you will need to place the 10" (25.4 cm) pedestal at least
9" (22.9 cm) above the floor. You will need to place the 15.5" (39.4 cm) pedestal at least
3" (7.6 cm) above the floor.
Optional pedestal (15.5" [39.4 cm] model shown)
The pedestals are available in several colors.
To order, call the dealer from whom you purchased your dryer or refer to the "Assistance or
Service" section.
P
edestal Height
10" (25.4 cm)
10" (25.4 cm)
15.5" (39.4 cm)
15.5" (39.4 cm)
15.5" (39.4 cm)
Stack Kit
Are you planning to stack your washer and dryer? To do so, you will need to purchase a Stack
Kit. To order, call the dealer from whom you purchased your dryer or refer to the "Assistance
or Service" section. Ask for Part Number 8212640.
Color Part Number
White MHP1000SQ0
Black MHP1000SB0
White MHP1500SQ0
Black MHP1500SB0
Pacific Blue MHP1500SK0