Buffalo G316 Mode D'emploi page 8

UK
X2 Presets
A further 10 Presets can be accessed/stored using the X2
default cooking times:
Key Number
Preset Cooking Time
(min:sec)
Note: Only single stage cooking programs can be stored in the X2 presets.
To store an X2 preset:
Press the PROGRAM button.
1.
Press the X2 button.
2.
Press the number button where the preset is to be stored.
3.
Select the power level.
4.
Enter the cooking time.
5.
Press the PROGRAM button to save the Preset Program.
6.
Press the STOP/RESET
7.
OR
Press the START button to begin cooking with that preset.
Automatic Start On/Off
In standby mode, press and hold the STOP/RESET
If a beep sounds and P L is displayed, auto-start is On. If a beep sounds and P is displayed auto-start is Off.
If auto-start is On the oven automatically commences cooking after pressing the required cooking Preset button.
To turn this function Off, so the appliance only starts cooking after the START
In standby mode, press and hold the STOP/RESET
1.
To turn the function back on:
In standby mode, press and hold the STOP/RESET
1.
L is displayed and a beep sounds.
P
2.
Operation Count
To see how many times the oven has been used:
Open the door.
1.
Press and hold the STOP/RESET
2.
While holding down STOP/RESET
3.
The number of times the oven has been used is shown on the display.
4.
4
button followed by the corresponding number button. Each button is preset with the following
1 2 3
0:20 0:40 1:00
button to return to Standby mode
button for 5 seconds.
button for 5 seconds. If P
button for 5 seconds.
button.
, press the POWER LEVEL
4 5 6
1:30 2:00 3:00
button is pressed:
L is displayed release the button and repeat so P is displayed.
button.
7 8 9
4:00 5:00 6:00
0
7:00