Publicité
Les langues disponibles
Les langues disponibles
CLEANING
Be sure that all control switches are
off and your appliance cooled before
cleaning
your oven. Plug off the appliance.
Control whether they are appropriate
and recommended by the
manufacturer before
using the cleaning materials on
your oven. As they may damage the
surfaces, do not
use caustic creams, abrasive cleaning
powders, thick wire wool or hard tools.
In case
the liquids that overflows around your
oven burn, the enameled place may be
damaged. Immediately clean the
overflew liquids.
Cleaning of Inside of Your Oven
Surely plug off the oven before starting
cleaning.
The inside of enameled oven is
cleaned in the best way when the oven
is warm.
Wipe the oven with a soft cloth that
had been hemmed in soapy water after
each use.
Later wipe it with a wet cloth once
more and then dry it. It may be
required to use a
liquid cleaning material from time to
time and make a complete cleaning.
Do not clean
with dry and powder cleansers.
Cleaning of Your Oven's Cover
In order to be able to clean the cover
of your oven from inside and outside,
use a glass cleaner. Then rinse, dry
it with a dry cloth. The cover can be
pulled out for cleaning as shown in the
following figure.
* Open the cover completely.
* Pass the metal pin through the holes
as shown on picture
* Do this process for both hinges.
* Lift up the cover slightly, pull towards
the outside smoothly. The cover will
completely
come out.
* Again place it into hinge holes while
pinning the cover to its place.
Do not clean the oven's cover while
the glass panels are hot. In case this
measurement
is not taken, the glass panel may brake
down. Contact to Authorized Service
whenany problem occured.
Requirements Before
Contacting to Service
If the oven does not operate;
The oven may be plugged off, there
has been a blow-out. On models fitted
with a
timer, time may not be regulated.
If the oven does not heat;
The heat may be not adjusted with
oven's heater control switch.
If the interior lighting lamp does not
light;
The electricity must be controlled.
It must be controlled whether the lamps
are defective. If they are defective, you
can
change them as following the guide.
EN - 23
Publicité
