Publicité
Les langues disponibles
Les langues disponibles
2.4 o
PerAting conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. handling / Operation
3.1 t
ools
Use only clean tools!
3.1.1 c
/f
hAnging
itting the tool
Hold spindle by wrench flats with open end wrench and
screw the tool. Perform a trial run a minimum over a pe-
riod of 30 seconds without load.
3.2 w
orking instructions
On failure of the compressed air release the valve
lever! To achieve an optimum result, move grin-
ding tool uniformly back and forth with light pres-
sure. Excessive pressure lessens the working capability
of the machine, as well as the life of the grinding tool.
4. Service / Maintenance
4.1 P
reventive mAintenAnce
Without a tool clamped in check no-load
speed periodically and after each mainte-
nance. Even if the machine still operates
perfectly, the motor should be removed, cleaned and the
four slides checked for wear by a specialist after approx.
300 to 400 operating hours. The lubricant in the gear
head (Isoflex NBU 15) should be replaced at the same
time (do not wash out!).
19
Publicité
