English
d) SECTIONS adjustment
The head-/backrest section is operated by rack (2)
The central section is operated by rack (2)
(2) Rack: Lift the section up to the required position and the rack will position itself automatically. To lower
the section, first raise it up to a certain extend or completely (as appropriate) in order to release the rack.
* The hinges on both sides must be properly fixed and positioned at the same height.
NEVER adjust any of the table sections WHILE THE PATIENT IS LEANING ON.
Safely position your FINGERS AND HANDS AWAY from the upholstery edge to avoid any
accidental jamming.
e) ACCESORIES Adjustment
The table you've bought includes the FACE CRADLE A4430.
It is stored underneath the upholstery and fixed by means of 3 clamps. To remove the face cradle simply
hold the metal frame and pull.
To install the face cradle, insert the bolts through the holes provided at the edge of the table.
You can adjust the cradle tilt by loosening the grips, then place it at the required position and tighten the
grips.
3) MAINTENANCE
For safety reasons, DISCONNECT THE TABLE from the electrical supply before the table
cleaning, repair or servicing.
a) FRAME
For a proper operation of the table, you should do the dusting regularly with a cloth, especially at the
moving parts.
Periodically check couch visually for any signs of damage and make sure that all bolts, nuts and other
fasteners are tight.
* The repeated exposure of the table to high levels of humidity is not recommended.
b) Electric MOTOR
Keep this piece free from any dust or grease.
Absolutely avoid spilling liquids on the motor because they could cause severe damage to the electric
components despite the motor protection.
THE HANDLING OF THE ELECTRIC MOTOR IS TOTALLY FORBIDDEN. Any manipulation will
invalidate the guarantee.
A non-stop blinking operation of the foot rail or any other height adjustment mechanism could activate the
thermal protection of the motor due to an overheating.
For further information, go to annex "FREQUENTLY ASKED QUESTIONS ABOUT MOTORS".
Examine the table periodically for any signs of damage or malfunction and contact immediately the reseller
or Ecopostural for service/ spare parts.
c) UPHOLSTERY
A wet cloth should be enough to do the dusting. Anyway, if the leather is not properly clean you can use a
smooth sponge soaked with neutral soap water. Dry immediately afterwards. To prevent moisture from
entering the seams, do not wash with abundant water.
It is highly recommended to use a towel cover like the A4469, A4459 or A4460 to protect the upholstery
* Ensure that the toothed pieces fit together
correctly before tightening them again.
14