Panasonic LUMIX DMW-FL360L Manuel D'utilisation page 15

Control panel
∫
Returning the custom settings to the default setting
Press and hold the [OK] button and [BACK LIGHT] button together for more
than 2 seconds
The control panel will blink once when settings are reset.
Display of the distance unit does not return to the default setting.
Camera without Communication Functions
∫
AUTO
Set aperture and ISO sensitivity to the values selected with the camera.
1 Set the flash mode to [AUTO].
"Flash Mode" (P10)
• When [AUTO] is selected, pressing [MODE] (3) button
allows you to set the aperture. Press the [MODE] (3)
button again to turn back.
2 Match the zoom position to the focal length of the lens.
"[ZOOM]" (P11)
3 Adjust aperture and ISO sensitivity.
"Other Settings" (P13)
If the selected values are out of the flash working range, [ISO] and [F] will blink in
the display. The [AUTO CHECK] lamp blinks for about 5 seconds after the shutter
is released to show that the flash has fired successfully.
Option Description
[m]: Distances displayed in meters.
Distance
[ft]: Distances displayed in feet.
units
[ON]: Flash detects position of wide panel.
Wide
Lighting angle adjusted automatically.
panel
[OFF]: Flash does not detect wide panel
detection
position.
Guide [ON]: Flash output is shown as a guide number.
number [OFF]: Flash output is shown as a relative value.
display
[ON]: The ISO sensitivity and the aperture are
adjusted to match the camera.
[OFF]: The ISO sensitivity and the aperture of
Auto light
the flash can be adjusted with the dial.
sensing
≥ This can only be used for digital cameras with
communication functions. (Only when the flash
mode is set to [AUTO] or [SL AUTO] mode.)
[25] to [3200]: Display the ISO sensitivity when
Auto ISO [AUTO] is selected as the flash mode for
display cameras that can not communicate with the
flash unit.
15
(ENG) VQT4Q07