Publicité
Les langues disponibles
Les langues disponibles
Wireless Flash Settings
Wireless control is available with Panasonic digital cameras that support wireless
mode. See the operating instructions of the digital camera for operation of the
digital camera during wireless flash shooting.
1 Set the camera to wireless mode.
2 Set the flash to [RC] mode.
"Flash Mode" (P10)
• When [RC] is selected, pressing [MODE] (3) button
allows you to set a channel. Press the [MODE] (3) button again to turn back.
3 Use the flash to select the channel and group.
"Other Settings" (P13)
Channel
Group
The Firing mode, the flash adjustment, and the manual flash adjustment can be set
for each group by operating the camera.
Placing Wireless Flash Units
Since the communication is performed with the flash emission of the camera, the
flash positioning range varies with camera. Refer to the camera operating
instructions for details about the flash positioning range.
1 Attach the supplied stand.
• Slide the lock lever in the direction opposite to that
indicated by the [LOCK 1] icon (1) and slide the flash
onto the stand until it clicks securely into place (2).
• Slide the lock lever to the [LOCK 1] position to latch the
flash in place.
• To remove the flash, slide the latch in the direction opposite to the [LOCK 1]
arrow and slide it from the stand.
2 Position the flash with the wireless sensor
(A) facing the camera.
Take a test shot after positioning.
≥ We recommend using a single group of up to three remote
flash units.
≥ Flash may not fire due to the angle or distance between the
camera and the object.
12
VQT4Q07 (ENG)
Set the camera and flash to the same channel.
The camera can adjust flash settings separately for up to 3
groups; choose the group to which the flash belongs.
Publicité
