Publicité
Les langues disponibles
Les langues disponibles
Connecting the drain line
Secure the drain hose in place to prevent moving and leaking.
NOTE
y
The drain hose should be properly secured. Failure to
properly secure the drain hose can result in flooding
and malfunction.
Total height of the house end should not exceed 96
y
inches (244.8 cm) from the bottom of the washer.
The drain must be installed in accordance with any
y
applicable local codes and regulations.
Make sure that the water lines are not stretched,
y
pinched, crushed, or kinked.
Using a standpipe
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from
the end of the drain hose. If the drain hose is extended
more than 4 inches (10 cm) beyond the end of the
elbow bracket, mold or microorganisms could spread to
the inside of the washer.
No more than
4 inches (10 cm)
Elbow bracket
2
Insert the end of the drain hose into the standpipe.
Drain Hose
3
Use a tie strap to secure the drain hose in place.
Using a laundry tub
1
2
3
Elbow Bracket
INSTALLATION INSTRUCTIONS
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from
the end of the drain hose. If the drain hose is extended
more than 4 inches (10 cm) beyond the end of the
elbow bracket, mold, or microorganisms could spread to
the inside of the washer.
No more than
4 inches (10 cm)
Elbow bracket
Hang the end of the drain hose over the side of the
laundry tub.
Drain Hose
Use a tie strap to secure the drain hose in place.
15
Elbow Bracket
Publicité
