Publicité
INSTALLATION
WARNING:
YOU MAY WANT TO LOCATE ANY UTILITIES
OR OBSTACLES INSIDE THE WALL BEFORE
ATTEMPTING
THIS
TO KEEP IN MIND YOUR UNIT'S CLEARANCE
REQUIREMENTS.
1.
Mark the area and then cut the wall for vent
installation if needed.
2. Install the wall thimble as specified by the
manufacturer (wall thimble sold separately)
3. Install venting.
INSTRUCTIONS SPECIFIC FOR CANADIAN
Do not obstruct the space under the heater and do not
obstruct the combustion air openings.
Refer to the chimney manufacturer's instructions for
disassembling the chimney/venting for transportation of
a transportable building.
The parts or materials to be employed for ember
protectors and the minimum areas to be covered and
their relation to the space heater, as well as the notice:
"In Canada, to comply with CSA B365, Installation Code
for Solid-Fuel-Burning Appliances and Equipment, any
combustible covering beneath the appliance and/or
within the area extending horizontally at least 450 mm
(18 in) beyond the appliance on any side equipped with a
door, and at least 200 mm (8 in) beyond the appliance on
other sides, shall be protected by a continuous, durable,
INSTALL.
MAKE
SURE
INSTALLATIONS
Ceiling
Support
TO STOVE
non-combustible pad that will provide ember protection.
The 450 mm (18 in) ember protection required on any
side with a door shall extend for the full width of the
appliance plus the 200 mm (8 in) required on each side
of the appliance without a door. Where an appliance is
installed less than 200 mm (8 in) from a wall, the ember
pad need only extend to the base of the wall. An ember
pad shall not be placed on top of a carpet unless the pad
is structurally supported to prevent displacement and
distortion.
If this appliance is installed in a transportable building,
removal of the chimney/venting is required for
transportation of the building.
DO NOT INSTALL IN AN ALCOVE
11
© 2023 United States Stove Company
Existing Class 'A'
6" Chimney System
Support
Bracket
3" to 6" Pipe
Adapter
3" PL Vent
Clean Out Tee
Publicité
