Publicité
Liens rapides
Owner's Instruction and Operation Manual
Model Number:
KP5522
Report Number: F22-782
Certified to ASTM E1509-12
(2017) and CAN/ULC S627:2021
Mobile Home / Transportable
Building Approved
* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.
Save These Instructions In A Safe Place For Future Reference.
SAFETY NOTICE: If this heater is not properly installed, a house fire may result. For
your safety, follow the installation instructions. Never use make-shift compromises
during the installation of this heater. Contact local building or fire officials about
permits, restrictions and installation requirements in your area. NEVER OPERATE
THIS PRODUCT WHILE UNATTENDED.
CAUTION! Please read this entire manual before you install or use your new room
heater. Failure to follow instructions may result in property damage, bodily injury, or
even death. Improper Installation Will Void Your Warranty!
U.S. Environmental Protection Agency
Certified to comply with 2020 particulate
emissions standards.
THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
© 2023 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380
R
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon
monoxide, which is known to the State of California to cause
cancer, birth defects, and/or other reproductive harm. For
more information, go to
853930B-0606M
www.P65warnings.ca.gov
Ph. 800-750-2723
Publicité
Manuels Connexes pour United States Stove KING KP5522
Sommaire des Matières pour United States Stove KING KP5522
- Page 1 State of California to cause cancer, birth defects, and/or other reproductive harm. For emissions standards. more information, go to www.P65warnings.ca.gov THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE. © 2023 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380 Ph. 800-750-2723...
- Page 2 This app is available only Text to 423-301-5624 or; on the App Store for iPhone and iPad. Email us at: Search US Stove. Save your receipt with customerservice@usstove.com your records for any claims. © 2023 United States Stove Company...
- Page 3 Declaration of Completion: As the qualified person responsible for the work described above, I confirm that the appliance as associated work has been installed as per manufacturer’s instructions and following any applicable building and installation codes. Signed: ______________________________________ Print Name: __________________________________Date: ______________ Home Owner: RETAIN THIS INFORMATION FOR FUTURE REFERENCE © 2023 United States Stove Company...
- Page 4 AND CAN BE HAZARDOUS TO YOUR HEALTH IF Freestanding Unit - supported by pedestal/legs and NOT PROPERLY VENTED. placed on a non-combustible floor surface in compliance with clearance requirements for a freestanding stove installation. © 2023 United States Stove Company...
- Page 5 2. Unpack the top mount controls and ensure that the wiring harness shown is attached securely. 4. Secure the control panel to the top of the stove with two sheet metal screws. © 2023 United States Stove Company...
- Page 6 (69FAK) which is necessary for a mobile home/ approved by a regulatory authority. transportable building. You can purchase the 69FAK through your heater dealer. Installation instructions are supplied with the air intake kit. © 2023 United States Stove Company...
- Page 7 90-degree elbows, or two 45-degree and one 90-degree • Vent must be 3 or 4-inch “PL” Vent and must extend elbow, etc.) to maintain adequate draft. a minimum or 36” (914 mm) above the roof line of © 2023 United States Stove Company...
- Page 8 Do not terminate the vent in an enclosed or semi-enclosed area, such as; carport, garage, attic, crawl space, under a G. Minimum 2-foot (0.61m) clearance below eves or sun deck or porch, narrow walkway, or any other location overhang. © 2023 United States Stove Company...
- Page 9 HORIZONTAL EXHAUST VENT INSTALLATION Locate your pellet stove in a location which meets the requirements of this manual, but in an area where it does not interfere with the house framing, wiring, etc. © 2023 United States Stove Company...
- Page 10 3ft (0.91m) to get above the having jurisdiction before you have a qualified snowdrift line. This same installation can be used if your installer proceed with this installation. heater is below ground level by simply adding the clean- © 2023 United States Stove Company...
- Page 11 (18 in) beyond the appliance on any side equipped with a door, and at least 200 mm (8 in) beyond the appliance on DO NOT INSTALL IN AN ALCOVE other sides, shall be protected by a continuous, durable, © 2023 United States Stove Company...
- Page 12 • The levels of heat output will incrementally change on • When room temperature drops below desired set-point the bar graph starting from heat range “1” to heat range the stove will ramp back up until it reaches the desired “5”. temperature. © 2023 United States Stove Company...
- Page 13 Your pellet stove is designed to burn premium hardwood WHILE THE STOVE IS PLUGGED IN. pellets that comply with the Pellet Fuels Institute (PFI) standard (minimum of 40 lbs density per cubic ft, 1/4” to © 2023 United States Stove Company...
- Page 14 • WE RECOMMEND THAT YOU NOT LET THE the “Heat Level Advance” button. HOPPER DROP BELOW 1/4 FULL. If the fire doesn’t start in 12 minutes, press “On/Off”, wait a few minutes, clear the burn pot, and start the procedure again. © 2023 United States Stove Company...
- Page 15 The stove will shut down and show “E2” on the two digit display. The stove has to fully shut down before restarting. © 2023 United States Stove Company...
- Page 16 CO. the top as well as from the bottom. The creosote should be removed with a brush specifically designed for the © 2023 United States Stove Company...
- Page 17 Gaskets Inspected 5. Re-install the retainer and eight nuts and rope gasket Glass Wiped Cleaned using high-temperature silicone to adhere the gasket Hopper (end of Empty & to the door. season) Vacuumed © 2023 United States Stove Company...
- Page 18 If the other items check out OK, replace the high limit switch. ATTENTION: THIS WOOD HEATER NEEDS PERIODIC INSPECTION AND REPAIR FOR PROPER OPERATION. IT IS AGAINST FEDERAL REGULATIONS TO OPERATE THIS WOOD HEATER IN A MANNER INCONSISTENT WITH OPERATING INSTRUCTIONS IN THIS MANUAL. © 2023 United States Stove Company...
- Page 19 If you hear a click, the air switch is working. BE CAREFUL TOO MUCH VACUUM CAN DAMAGE THE AIR SWITCH. © 2023 United States Stove Company...
- Page 20 The control board is not sending power to the POF There should be a 5-volt (approximately) current going to the thermodisc or other auger system components. POF thermodisc after the stove has been on for 10 minutes. © 2023 United States Stove Company...
- Page 21 If the sensor is not unplugged then turned on the sensor is damaged or has a short. If the sensor is damaged or has a short it will need to be replaced. © 2023 United States Stove Company...
- Page 22 Circuit board malfunction. board is fine. If there is NOT power being sent to the blower when it shuts off during operation, then you have a bad control board. © 2023 United States Stove Company...
- Page 23 If there is not a full current going to the auger motor when the fuel feed light is on, you have a bad control board. © 2023 United States Stove Company...
- Page 24 Bad Pellets. (Applies to GLASS “SOOT’S” UP AT A You might also want to try a brand that is made from a different VERY FAST RATE Only) type of wood (softwood vs. hardwood). Different woods have different characteristics when being burned. © 2023 United States Stove Company...
- Page 25 Part numbers and descriptions can be found in the “Repair Parts” section of this manual. Once this information has been gathered you can contact customer service by phone 1-800-750-2723 Ext 5051 or Email parts@usstove.com. Model Information Model Number Serial Number © 2023 United States Stove Company...
- Page 26 Door Handle Kit 88118 Ignitor Flange Gasket IN ORDER TO MAINTAIN WARRANTY, COMPONENTS MUST BE REPLACED USING USSC PARTS PURCHASED THROUGH YOUR DEALER OR DIRECTLY FROM USSC. USE OF THIRD PARTY COMPONENTS WILL VOID THE WARRANTY. © 2023 United States Stove Company...
- Page 27 Engineer Name: ____________________________________ Engineer Name: ____________________________________ License No.: ________________________________________ License No.: ________________________________________ Company: __________________________________________ Company: __________________________________________ Telephone No.: _____________________________________ Telephone No.: _____________________________________ Stove Inspected: Chimney Swept: Stove Inspected: Chimney Swept: Items Replaced: ____________________________________ Items Replaced: ____________________________________ © 2023 United States Stove Company...
- Page 28 NOTES © 2023 United States Stove Company...
- Page 29 NOTES © 2023 United States Stove Company...