Publicité
Les langues disponibles
Les langues disponibles
DEFROSTING THE FREEZER
A layer of frost in the freezer will impair refrigeration of the frozen food and increases power
consumption. Remove the layer of frost regularly. Do not scrape off frost or ice with a knife or pointed
object. Doing this may damage the refrigerant tubes.
1.
Remove the frozen food and place temporarily in a cool location.
2.
Disconnect the appliance from the mains socket. Open the drainage opening and place a bucket
under it to catch the melted water.
3.
To accelerate the defrosting process, place a pan of hot water on a stand in the freezer.
4.
Wipe up condensation with a cloth or sponge.
5.
Wipe dry the freezer compartment. Close the drainage opening again.
6.
Plug in the appliance and adjust the temperature control knob as desired.
7.
Put the frozen food back in the freezer.
TROUBLE SHOOTING
Frequently, a problem is minor and a service call may not be necessary, use this trouble shooting guide for
a possible solution.
Does not work
·
Check connection of power cord to power source.
·
Plug in unit.
·
Use proper voltage.
Cools too frequently
·
The temperature setting is too cool.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and minimize door openings.
·
Do not place unit close to heat sources or direct sunlight.
Internal temperature not cold enough
·
Plug in unit.
·
Check setting and adjust as needed.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and minimize door openings.
·
Allow room for air to circulate around unit.
·
Use proper voltage.
·
Do not place unit close to heat sources or direct sunlight.
Unusual sounds
·
The appliance is not level. Readjust the adjusting feet and level the unit.
·
The unit it touching a wall or another object. Gently move the appliance.
The door does not close properly
·
The door seal is deformed. Heat it gently using a hairdryer. The rubber seal will become flexible and
the magnetic strip in the rubber will automatically pull towards the appliance. After cooling, the
rubber stays in that position.
48
DO91219F
Publicité
