Linea 2000 DOMO DO91219F Mode D'emploi page 44

Les langues disponibles

INSTALLATION

Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the

inside with a wet, lukewarm cloth. Dry the appliance off well.

Let air circulate freely around the cabinet.

Make sure there is sufficient space to open the door.

This cooling unit is not intended for use as a built-in appliance.

Select a place with a strong, level floor.

Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will

cause higher electricity consumption.

Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the

evaporator, and your freezer.

Before connecting your freezer to the power supply, check that the voltage stated on the rating label

of your appliance corresponds to the voltage in your home. A different voltage could damage the

appliance.

After installation, leave the freezer for 24 hours before turning it on. This way the refrigerant can

settle.

Allow the appliance to run empty for 12 hours so the compartment can cool to the appropriate

temperature.

The climate class indicates the minimum and maximum ambient temperature for the proper operation

of an appliance. You can find the climate class on the type plate on the back of the appliance.

SN: Subnormal: ambient temperature between 10°C and 32°C

N: Normal: ambient temperature between 16°C and 32°C

ST: Subtropical: ambient temperature between 16°C and 38°C

T: Tropical: ambient temperature between 16°C and 43°C

MOUNTING THE HANDLE

Remove the screws (5x) from the lid of the freezer with a cross-head screwdriver.

Mount the handle with lock on the lid of the freezer and fasten it with the 5 screws.

Place the cover on this handle.

DO91219F