Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Switching on
EN 8
• Press the "on/off" button (1) to switch on the appliance.
The indicator will light up when the appliance is switched on.
• Select the desired cycle (see page 10 "cycle selection table").
Turn the program knob (9) to select the required cycle. The indicator
(4) corresponding to the selected cycle will light up.
• Press the 'Start/Reset' button (8). The dishwasher will automatically start
running the selected cycle.
Delayed start time
If you want the dishwasher to switch on at a later time, you can used
the "delayed start" button (2). You can choose to delay the start time by
3, 6 or 9 hours. The indicator (6) corresponding to the selected delayed
start time will light up. Press the 'Start/Reset' button (8).
Select half load
The dishwasher with Half Load Washing Function adapt to your needs,
so you can save energy consumption, water consumption as well as
cycle duration by loading dishes of half capacity anywhere you prefer.
Stopping or changing a wash cycle
Press the 'Start/Reset' button (8) to switch off the program. Press and hold
the 'Start/Reset' button (8) for more than 3 seconds. You can now re-select
the desired cycle (see page 10 'cycle selection table).
Note! A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Detergent
compartment).
Publicité
