Drinkwell PWW17-16930 Guide De Démarrage Rapide page 6

5. Place the pump and foam filter into the bottom of
the bowl inside the square indentation as shown.
Press down to engage the suction cups.
Note: Wetting the suction cups will ease
the assembly.
6. Once the pump and foam filter are securely in
place, feed the cord through the raised post and
out the notch on the base of the bowl.
7. Remove the extra slack from the cord and push
the rubber seal firmly into the raised post. (Refer
to image #6)
8. Rinse the carbon filter thoroughly under cold
water to remove any loose carbon dust. Open
the filter housing and rinse both parts under
water. Insert the filter into the filter housing base
with the larger side facing down. Attach the
filter housing top and press down until it snaps
in place.
9. Insert the filter housing into the hole on top of
the pump.
6
5
6
Rubber Seal
8
9
petsafe.com
Notch
Raised
Post