Philips PE 1515 Notice D'emploi page 7

CAE N J R AL
A. INTRODUCTION
The stabilizer PE 1515 is intended for supplying electrical and electronic circuits.
The apparatus supplies:
- as a voltage stabilizer, a direct-voltage adjustable between 0 and 30 V
-as a current stabilizer, a direct-current adjustable between 0 and 12.5 A.
The stabilizer is provided with an over-voltage protection (crowbar) adjustable between 3.5 and 35 V.
Extra connections at the rear enable the following operations to be carried out:
- remote sensing
- remote voltage- or current-programming
- series or parallel connection according to the ''master and slave'' system
- parallel connection of the over-voltage protection (crowbar) when stabilizers are connected in
parallel.
B. TECHNICAL DATA
1. Input
Voltage s 220 V. 00). 5.60) Ez
Maximum current A Book LN
Power consumption : maximum 660 VA
Mains fuses : 2 fuses VL1 and VL2, each 6.3 A action delayed
Mains switch : 2-pole
2. Output
a. As voltage stabilizer
Voltage : -0...30 V continuously adjustable with the knob
marked ''U"
- resolution < 20 mV
Serie connection : - 3 apparatus max.
- the voltage between any one of the output terminals
and earth may not exceed 90 V =
- for series connection according to "master and
slave" system, see under point 3.e. of chapter IT. B.
Current : 12.5 A max. for each value of the output voltage
Parallel connection . : - Arbitrary number, provided the over -voltage
protections are also parallel-connected (connect
terminal 10 mutually)
- For parallel connection according to "master and
slave" system, see under point 3.f. of chapter II. B.
Stability : For mains voltage variations of +10 % of the nominal
value, the fluctuation of the output voltage is < 0.03 %
of the set value or < 1 mV.
Whichever is greater applies.