Renkforce DS100-8M Mode D'emploi page 34

b) Setting the Language
• Push the " Left/Mirror" button (2) or the "Right/Flip
peatedly until the corresponding submenu has been chosen; see figure on
the right or chapter 10. a).
• Push the "OK/ENTER" button (4) briefly to confirm.
• Use the " Left/Mirror" button (2) or the "Right/Flip
guage.
• Push the "OK/ENTER" button (4) briefly to confirm; then the slide scanner returns to the
main menu.
c) USB mode
When the slide scanner is connected to a computer's USB port by the USB cable, Windows
hardware recognition is not performed immediately. The slide scanner only uses the USB port
for power supply here.
Important!
Therefore, connect the slide scanner only to a USB port of your computer or a USB
hub with a separate mains adapter.
If you activate USB mode, the slide scanner will act as a USB drive or card reader; Windows
will recognise the new hardware and mount the SD/SDHC memory card or internal memory as
additional drive.
If an SD/SDHC memory card is inserted in the scanner's slot (10), the internal memory
is deactivated.
Then you can copy or move the data from the SD/SDHC memory card or internal memory onto
the computer and edit them there.
Proceed as follows:
• Push the " Left/Mirror" button (2) or the "Right/Flip
peatedly until the corresponding submenu has been chosen; see figure on
the right or chapter 10. a).
• Push the "OK/ENTER" button (4) briefly to confirm.
• The slide scanner activates USB mode and the operating system will recognise the new
hardware as a removable media drive. A drive letter is assigned automatically in Windows.
• Push the button "Convert/Mode
34
" (6) to terminate USB mode.
" button (7) briefly re-
" button (7) to select the desired lan-
" button (7) briefly re-