Clatronic KA 3701 Mode D'emploi page 39

WARNING:
• Before cleaning, always remove the mains plug and wait until
the appliance has cooled down.
• Do not immerse the appliance in water. Otherwise this might
result in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Disassembling the Appliance for Cleaning
1. First, allow the appliance to briefly cool down after use.
2. Pull the cover upwards and allow the appliance to cool
down completely.
3. Remove the permanent filter insert.
4. Slightly twist the grinding insert counterclockwise
towards UNLOCK. Remove it.
5. To remove the bean container / ground coffee container /
brewing head, push it towards
it up.
Basic Appliance, Cover
• The exterior of the appliance should be cleaned as nec-
essary with a slightly damp cloth – without any additives.
• Remove spilled coffee grounds with a paper towel from
the inner casing. Afterwards wipe with a damp cloth.
• Remove adhering powder in the grinder with the clean-
ing brush. Use a vacuum cleaner to remove the coffee
powder residues from inside the grinder.
Glass Jug with Lid, Permanent Filter Insert,
Measuring Spoon
Clean the parts in a rinsing bath in the usual manner. Use a
soft brush if necessary.
Problem
The appliance does not work. The appliance is not connected to mains
KA3701_IM
Cleaning
. Remove it by pulling
Troubleshooting
Possible Cause
power.
The appliance is equipped with safety
switches. These prevent it to switch on
without the cover being in place.
The overheating protection has been
activated. The motor is too hot.
The appliance is defective.
Grinding Insert, Bean Container / Ground Coffee Con-
tainer / Brewing Head
Clean these parts under running water.
Assembling the Appliance After Cleaning
Allow all parts to completely air dry after cleaning before
reassembling the appliance.
1. Reinsert the bean container / ground coffee container /
brewing head slightly tilted. Push it until it stops towards
.
2. Replace the grinder. Slightly tighten it towards LOCK.
3. Install the permanent filter insert.
4. Place the cover back on.
Storage
• Clean the appliance as described and let it dry com-
pletely.
• We recommend that you store the appliance in its
original packaging when it is not to be used for a longer
period.
• Always store the appliance at a well ventilated and dry
place outside the reach of children.
Solution
Check the wall outlet with a different appliance.
Insert the plug properly in the wall outlet.
Check the fuse.
Check that the cover is fitted properly.
Let the appliance cool down for at least
20 minutes before switching it on again.
Contact our service or a repair centre.
39
20.04.18