Beamz professional BBP66 Manuel D'instructions page 6

BATTERY STATUS
When the power lead is not connected and you don't touch the menu buttons, then the display shows the battery status
automatically after a while.
Display
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
•
Make sure the area below the installation place is free from unwanted persons during servicing.
•
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected.
•
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
•
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
6
Status
Battery is charge for 100%
Battery is charge for 75%
Battery is charge for 50%
Battery is charge for 25%. Light output is automatically reduced to 60%.
When display is blinking, the light output is automatically reduced to 10%. Please plug in the
power lead and connect with outlet immediately. If not, the product will turn off after 10
minutes.