Functioning - Brandt BC52N Manuel D'instruction

3.2 Functioning

The weighing
Tare function

Please put the scale on hard flat table.
 Touch to switch on (image 1 and 2)

You can start to weigh when "0" is shown on the LCD. (image 3)
 Please put the weight into the middle of the container, the weight
data will be shown (image 4 and 5)
Note: If there is not any operation and the weight is steady in weighing
mode, the scale will turn off automatically after about 60s.
The tare function reset the display to zero even though there is an object
on the balance. Thus, the display will indicate the mass of any new
material placed on the balance after the tare button has been depressed.
 Put the container on the platform (image 2 and 3) and touch
to set the weight to zero (image 4 and 5)

Please put the weight onto the middle of the container, the
weight data will be shown (image 6 and 7)
 Note: If there is not any operation the scale will turn off
automatically after about 60s.
18