TREVIDEA G3 Ferrari LIBECCIO STAND Mode D'emploi page 11

ASSEMBLING
The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the
maximum safety, perform the installation completely before operating.
1) Joint the 2 bars so as to form a cross.
2) Place the lower tube (11) at the center of the base (18) by aligning the holes in the base with the slots on
the bottom of the tube. Tighten the 4 screws for fixing the base (12), squeezing them hard.
3) Unscrew and remove the tube from the height adjustment knob (9).
4) Insert the tube in the cover of the base (10) to cover the assembling screws (12)
5) Remove upper tube (8) from lower tube (11) to the desired length and secure by tightening the knob (9).
6) Insert the motor unit into the upper tube (8) and tighten the locking knob of the motor housing (7) to lock
both sides.
7) Place the rear grid (3) near the plastic of motor (4) with metal handle facing upwards. Fit the holes placed
in the central part of grid with the pins in plastic protection (4) and secure the parts with the stopper (15).
8) Insert the fan (2) in the drive shaft (13) and thread the stopper (16) to the threaded end of the crankshaft.
9) Remove the fixing screw (17).
10) Place the front grid (1) in front of the rear grid (3) matching the holes on the grids.
11) Close the locking pins and fasten the two grids tightening the securing screw (17) previously removed.
The fan is now correctly assembled.
OPERATING
Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical
outlet. By using control panel (14) the rotation power can be adjusted on different speeds.
0: fan is OFF
OSCILLATION
The oscillation of the head is only possible when the fan is turned on and it can be activated by pressing the
pin (5) downwards until it locks. Lifting the pin (5) until the locking function is disabled.
It is recommended to enable or disable the oscillation of the fan only when the unit is off.
CLEANING
Disconnect the plug from the electrical outlet before attempting any cleaning operation.
Do not immerse the unit in water. In any case prevent splashes of water or other liquids reaching the motor
body. Do not clean the unit with metallic sponges or abrasive cleaners, only use neutral detergents and a soft
cloth moistened with water to clean the outer parts.
Dry the product completely before operating the unit.
TECHNICAL FEATURES
•
Power supply: AC 230V
•
Fan diameter: 40cm
•
3 operation speeds – Oscillation
PORTUGUÊS: ADVERTÊNCIAS
As indicações seguintes são muito importantes no que se
refere à instalação, uso e manutenção deste aparelho;
conserve com cuidado este manual para eventuais futuras
consultas; utilize o aparelho apenas do modo indicado
1: low speed
~
50-60Hz. Max input power 45W
2: medium speed 3: high speed
10