Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL PRUNING SHEAR
15. MAINTENANCE & CLEANING
Tools to be repaired must be sent to Customer Assistance Service.
Use original part keeps the tool good condition and safe.
Switch off the battery power and disconnect the tool before to
check, maintain and repair the pruning shear, to avoid risk of
unexpected actuating of the tool.
Please wear glove before you check the blade sharp or not, that's
avoid blade hurt you.
•
Check the pruning shear frequently, this will keep tool safe and reliable.
•
Don't flush the tools or put it in water, it will cause short circuit or damage
the device.
•
Keep ventilation, motor and handle cleaning, always use feather clean the
device. Don't use cleanser flush device, it will rust parts.
•
Clean the blade after every use, protect by oil or spray protection.
•
After continuous work for 8 hours, please open the front cover of the
equipment and clean up wood chips and other impurities.
15.1 SHARPENING
Sharpening is very important to keep blade in good condition and ensure
long life.
•
The tool have attached accessory to sharp blade.
•
Always check blade is in good condition before to start work.
•
The frequency of sharpening depends on the nature of the sheared wood
(hardness and diameter), pruning rate and sharpening tools (special
abrasive tools are provided).
72
www.kamikazevolpi.com
Publicité
