Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL PRUNING SHEAR
•
When operating a power tool out-doors, use an extension cord suitable
for outdoor use. Use of a cord suitable for outdoor use reduces the risk
of electric shock.
•
If operating a power tool in a damp location is unavoidable, use a residual
current device (RCD) protected supply. Use of an RCD reduces the risk of
electric shock.
3.3 NOTICE OF USING THE TOOLS
•
Don't over load the tool, select suitable tool to work make you safe and
high efficiency.
•
Don't use the tool if the switch doesn't work properly. Tool should be
repaired if the switch doesn't work.
•
Disconnect the tool from battery or power source before adjusting, repair,
replace or storage the tool. This will avoid injuries due to unexpected
start of the tool.
•
Store the tool away from the children, don't put tool to non-training
person operate.
•
Maintain tools. Always check tool, moving parts, any damage parts are
all can cause injury, the correct maintenance of the tool can avoid injury.
•
Keep blade sharp and clean. Sharp and clean blade can be easily controlled
and not jams.
•
Read manual before using the tool, select suitable tools and right
accessories to avoid injury.
3.4 NOTICE USING CORDLESS TOOL
•
Ensure that the switch is in OFF position before connecting the battery.
Insert battery and connect tool at switch in ON position will cause damage
to the battery and risk of injuries.
•
Use only the charger specified by the manufacturer. Use of other charger
can damage the battery and cause risk of fire.
60
www.kamikazevolpi.com
Publicité
