BH Magna Pro Instructions De Montage Et Utilisation page 16

ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.0.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(1) Monitor.
(120) Main structure.
(5) Monitor support.
(50) Side bar (left).
(51) Side bar (right).
(73) Mains cable.
(74) Mains cable fastening cover
(146) Side bar base cover (Left).
(147) Side bar base cover (Right).
(128) Bottle of lubricant.
(17) Bottle holder.
(3) Self-locking nuts M-8.
(55) Allen screw M-5x15.
(52) Allen screw M-8x75.
(79) Self-tapping screw 3.5x15
(153) Bottle.
Combination box spanner.
Allen key 5mm.
(135) Allen key 6mm.
Follow the instructions step by step to
assemble:
1. At least two people are needed for
this step.
When fitting the side bars, one person
should hold the side bar while the
other one tightens the screws (52).
This will prevent
accidents.
First, take the right-hand side bar (51),
Fig.1.
Insert the tip of the control cable (35)
tying it to the guide cable (N) inserted
in the side bar Fig.1, pull the tip out
through the top of the side bar, as
shown in Fig.1, then insert the side
bar into the bottom right-hand support
any possible
on the structure (120) and use screws
(52) to secure it.
2. At least two people are needed for
this step.
When fitting the side bars, one person
should hold the side bar while the
other one fits the screws (52). This will
prevent any possible accidents.
3. Now take the left side bar (50) and
insert it into the bottom left-hand
support on the structure (120) and use
screws (52) to secure it.
4 Position the left and right base
covers (146) and (147) in the direction
of the arrow facing the corresponding
side bar, as shown in Fig.2 and attach
them by using screws (55), as shown
in Fig.2.
5. ATTACHING THE MONITOR
TUBE.-
Insert the tip of the control cable (35)
tying it to the guide cable (R) inserted
in the monitor tube Fig.2, pull the tip
out through the top of the monitor
tube, as shown in Fig.2, and making
sure not to pinch any of the cables
when inserting these onto the handrail
tubes in the direction of the arrows.
Now tighten using self-locking nuts (3)
Fig.2.
6. ATTACHING THE MONITOR.-
Take the
terminals (H); (L), (34) and (35),
coming out of the handlebar (5) Fig.3,
to the terminals (J); (141), (140) and
(139), of the monitor, next take the
screws (52-175)
monitor, making sure not to pinch the
cables.
7. Next, lift the two bottle holder (17)
over the sides of the monitor Fig.4 in
the direction of the arrow.
16
monitor (1),
and secure the
connect