Publicité
Les langues disponibles
Les langues disponibles
• Align the nozzle section 90 degrees to the
motor housing and press it fully into the motor
housing as shown in figure T.
• Grasp the nozzle section and twist it
downward until the pointer on the nozzle
section aligns with the lock symbol on the
motor housing (figure U).
When properly connected, the two pieces will
"snap" into place.
Use only mild soap and damp cloth to clean the power unit. Never let any liquid get
inside the power unit; never immerse any part of the power unit into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (other than those listed in this manual) should be performed by
authorized service centers or other qualified service organizations, always using
identical replacement parts.
The sprayer contains a washable/reuseable filter (figure V). Check the filter
before and after each use. If dirty, wash with warm water and allow to air dry
before re-installing or replace if necessary.
• To check the filter, remove the filter cover by loosening the two screws in the
cover and pulling the cover off the sprayer. Remove the filter as shown in figure V
and inspect. Replace filter and filter cover. Snugly tighten screws. Never operate
the sprayer without the filter in place. Debris could be sucked in and interfere with
the function of the sprayer.
Make sure unit is clean and dry before storing. Store unit indoors in a dry location.
To prevent damage, wrap the electrical cord so that it is not crimped during
storage.
Recommended accessories for use with your product are available from your local dealer or authorized service
center. If you need assistance regarding accessories, please call: 1-800-544-6986
WARNING: The use of any accessory not recommended for use with this product could be hazardous.
All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable
power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black
& Decker location nearest you. To find your local service location, refer to the yellow page directory under "Tools—
Electric" or call: 1-800-544-6986 or visit www.blackanddecker.com
Tool service must be performed only by qualified repair personnel.
WARNING::
When servicing a tool, use only identical replacement parts.
WARNING:
Full Two-Year Home Use Warranty
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship. The
defective product will be replaced or repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased
(provided that the store is a participating retailer). Returns should be made within the time period of the retailerʼs policy
for exchanges (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with the retailer
for their specific return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or authorized Service Center for
repair or replacement at our option. Proof of purchase may be required.Black & Decker owned and authorized Service
Centers are listed under "Tools-Electric" in the yellow pages of the phone directory.
T
MAINTENANCE AND STORAGE
ACCESSORIES
SERVICE INFORMATION
WARRANTY
11
U
V
Publicité
