Black & Decker HVLP SMARTSELECT BDPH200 Manuel D'instructions page 10

• Separate the nozzle section from the sprayer
motor by pressing the release button on the
motor housing as shown in figure N.
• Grasp the nozzle section and twist until it is
90 degrees to the housing, then pull straight out
(figure O).
• If using water based material, clean the nozzle
section by running water through pickup tube
inlet as shown in figure P. If using oil based
materials, clean pickup tube inlet with the
appropriate cleaning solution. Repeat until
sprayer is completely clean.
• Dry all parts thoroughly.
• Properly dispose of cleaning solution.
• Place a drop of household oil onto the metal
ball in the check valve
(figure Q). IMPORTANT: Lubricating the ball
in check valve, after cleanup, will help to
prevent it from sticking which can clog the
valve and prevent adequate flow of spray
material.
NOTE: When reassembling, place metal ball
end of check valve into sprayer.
• Reassemble sprayer (figure R). NOTE: The
spray tip can only go in one way. The notch
on the spray tip, shown in figure S must
align with the recess in the threads of the
sprayer.
N
P
Q
S
10
O
R