Publicité
Les langues disponibles
Les langues disponibles
F
5. USING THE LED LIGHT
To turn on the light simply press the on/off switch. When you release the on/off switch, the light
will be off. LED lighting increases visibility-great for dark or enclosed area. LED is also a battery
capacity indicator. It will flash when power gets low.
6. OVERLOAD CLUTCH
1) If the tool insert becomes caught or jammed, the drive to the drill spindle is interrupted.
Because of the forces that occur, always hold the power tool firmly with both hands and
provide for a secure stance.
2) If the power tool jams, switch the machine off and loosen the tool insert. When switching the
machine on with the drilling tool jammed, high reaction torques can occur.
7. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for, the power tool cannot be subject to overload. When the load is too
high or the allowable battery temperature of 75°C is exceeded, the electronic control switches
off the power tool until the temperature is in the optimum temperature range again.
8. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by the "Discharging Protection
System". When the battery is empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
ORIGINAL INSTRUCTIONS
4. FUNCTION MODE SELECTION (SEE FIG. F)
The operation of the gearbox for each application is
set with the function selector dial. To change between
functions, rotate the function mode selection switch to
the desired operating mode.
WARNING! The operating mode selector switch
may be actuated only at a standstill.
33
SAFETY AND OPERATING MANUAL
Mode for simultaneous drilling and
impacting of concrete, masonry
Mode for drilling into steel, wood and
plastics
Mode for or chiseling
Mode for adjust the chuck angle of
chiseling
NOTE: Select this function mode "
first, adjust the chuck angle to desired
direction. Then select the function mode
to "
", operate the chiseling work.
"
Publicité
